3/8-16 Zinc Round Base T-nuts
#9 is a half inch edge, flat and requires body tension as the wall gets steeper. Sold as a set of 2.
We've all tried to pinch a 2 x 6 rafter at one time and this hold is very similar to that feel. At just over 2 inches wide, get your pinch on! You can cheat the pinch with an index finger but that should not discourage you. That's a great way to make the hold a little easier until you can pinch it full on. Rotating it long ways like an edge gives you a very large open handed edge. One of my favorites.
Sold as a set of 2 holds.
A full pad incut edge suitable for a hang board or a system wall. Great for a beginner hang board as an intro to crimping or for some power endurance pull down action in your next system session.
Sold as a set of 2.
55 East 600 South, Provo, Utah 84606
Tel. 801-404-0280 | firstname.lastname@example.org