Metal Dry Tooling 1" x 2-3/4" Bridge (5/32" Holes)

The second largest hole that is offered on a bridge.


The 1" x 2-3/4" Bridges differ from our smaller 3/4" x 2" Bridges because they are more difficult to find the holes and dimples. This is because the 1" x 2-3/4" Bridge has more surface area yet has the same amount of holes and dimples as the smaller Bridge. 

More precision is required on these 5/32" holes than on the 13/64" model.  You get partial pick penetration for the tip of your pick.  The beak of your pick does not go entirely through the 1/4" thick bridge. 

This is a great hold to teach accurate tool placement, as well as teaching pressure control to stay on. 

The bridge is attached perpendicular to the backplate. 

Size: 3 x 5/32" holes 

Stands off the wall: 1-3/16"

Backplate: 3" x 5" Oval

Bridge Orientation: 0 degrees/Perpendicular to the back plate 

Material:  Stainless steel

Hardness Comparison: View Chart and Descriptions

Warranty:  Lifetime 

RESPONSIBILITY: Please be aware that it is unacceptable to drytool at your local crag. Drytooling damages natural rock. You should drytool only in places where the local community has dedicated the area and never on established rock climbing routes. 

DRY TOOLING ETHICS: What You Should Know before heading out.