Overview
This bridge has a 3/4" radius bite out of a 2" tall by 5" long bridge. It acts like a jug on steep walls up to 60 degrees overhanging. Once passed 60 degrees, the radius is close to horizontal to the ground where your tool can skate off if the hold is facing you.
When placed on a surface horizontal to the ground, the incut is down-sloping, creating an advanced level hold.
Check out Dry Tooling Large Shark Fin for an easier version.
Size: 3/4" radius.
Bridge: 2" tall x 5" long.
Backplate: 4" wide x 6" long.
Material: Stainless Steel
Warranty: Lifetime
RESPONSIBILITY: Please be aware that it is unacceptable to drytool at your local crag. Drytooling damages natural rock. You should drytool only in places where the local community has dedicated the area and never on established rock climbing routes.
DRY TOOLING ETHICS: What You Should Know before heading out.
55 East 600 South, Provo, Utah 84606
Tel. 801-404-0280
cs@atomikclimbingholds.com
